Firmware Flash Recovery for M2 Router via TFTP

  • Updated

If your M2 router's LED light is flashing red and green alternately, you can use this guide to restore it.

 

To complete this process, you'll need a Windows PC that is connected directly to your M2 router via Ethernet cable. You'll also need to know how to change the IP settings on your Ethernet adapter, and be comfortable restoring them back to defaults afterwards.

 

Step 1 - Download the files you'll need

 

Download the attached files and store them somewhere handy on your PC.

 

 

Step 2 - Change your adapter settings

 

Type 'Network Connections' in to your start bar, and then select 'View Network Connections':

 

mceclip3.png

 

Locate the Ethernet adapter that is plugged in to your M2 router, then right-click it and select 'Properties':

mceclip4.png

 

Select 'Internet Protocol Version 4', and then select 'Properties':mceclip5.png

Finally, set the IP addressing according to the following exactly, and then click OK:
(Once you're done, you'll change these back to 'Obtain an IP address automatically'.)

mceclip6.png

 

Step 3 - Flash the recovery firmware

 

Locate the tftp32.exe application, and then click-click to run it as an administrator. Click 'yes' on the prompt that appears:

mceclip8.png

 

In the 'server interfaces' dropdown, select the interface that you configured previously. (It will have the IP address 192.168.1.100 on it):

mceclip3.png

Select the 'Tftp client' tab, enter '192.168.1.6' for the host, and then click the '...' button to select the .bin firmware file:

mceclip4.png

Finally, click the 'Put' button:

mceclip5.png

 

You should see a file transfer take place, which may take a minute or two to complete.

After the transfer, you should see the following confirmation:

mceclip1.png

Please wait for up to 5 minutes for the device to finish writing the received file to its flash memory. Once this is done, the power LED will turn red and the device will be rebooted with default settings.

The device can now be configured per normal instructions.

 

Congratulations! The firmware has now been restored.

 

Step 4 - Restore your IP settings

Repeat step 2 to return to your Ethernet adapter's IPv4 settings. At the final step, select the options to obtain your IP address and DNS settings automatically: mceclip0.png

 

Was this article helpful?

1 out of 2 found this helpful